Sunday, January 31, 2010

Maytag Washer Pavt234aww Manual What Could Be Causing My Maytag Washer To Leak Water?

What could be causing my Maytag washer to leak water? - maytag washer pavt234aww manual

I have a top-loading Maytag washing machine. Recently, it has a water leak from below. This happens only when the washing machine is filled with water. Also occurs regardless of the weight of the load I'm running. I do not think that the water overflows, for my burden is too great. This happens regardless of the load.

The washing machine is about 3 or 4 years are no longer under warrently. So you think it will eliminate even more costs than it would be just to get a new one?

3 comments:

Anonymous said...

Mine was done and was not really that water comes from below. If you are on the back of the machine there are 2 hoses screwed into the cold and hot water. What is the screw in a small water pump was leaking and it runnning the inside of the window again, showing that the water from below.
When you practice, you can pump into the top of the cover and turn the machine begins to fill with water, can see if is, where leakage occurs. This part is relatively cheap and easy to replace.

Anonymous said...

I had exactly the same problem with my 10 years old Kenmore washer to load up. Just drain during the filling cycle.
Clogs Lint finally be in the water tray that higher chlorine accepted.

You see, a little water is always crowded ferry diverted water down and to abandon to be poured all the chlorine in the upper reservoir.

You may have to Google "how to make a washing machine" to abolish, to the lid of the washing machine. In my case it was a few screws release into the Control Panel, then leave some strategically placed screwdriver release to the clip Now the top of the chassis. The bridge over the turning point, access to the top of the washing machine drum. And now, all the dirt Linty clean, opening holes for drainage and was like new!
Good luck!

Anonymous said...

Probably a simple solution.

Check all hoses and connections.

Tires front and rear of the device and delete and search for cracks and loose connections.

Most likely cheaper to replace the pipe or hose and clamps to buy a new washing machine. Washing can be really expensive if you buy used.


:-)

Post a Comment

 
Copyright 2009 Clear warmers Advanced. Powered by Blogger
Blogger Templates created by Deluxe Templates
Wordpress by Wpthemesfree